Fall protection is the use of controls designed to protect personnel from falling or in the event they do fall, to stop them without causing severe injury. … Federal statutes, standards and regulations in the United States pertaining to the requirements for employers to provide fall protection are administered by OSHA.
What is the purpose of fall protection?
Why is fall protection important? Falls are among the most common causes of serious work related injuries and deaths. Employers must set up the work place to prevent employees from falling off of overhead platforms, elevated work stations or into holes in the floor and walls.
What item is an example of fall protection?
Functional Systems of Fall Protection
Some exceptions exist, including (but not limited to) ladders, scaffolding, and steelwork. Common fall arrest equipment includes an anchor point, body harness, and connector (such as a lanyard or self-retracting lifeline.
When should fall protection be used?
When must employers provide Fall Protection? The 6-foot rule. Subpart M requires the use of fall protection when construction workers are working at heights of 6 feet or greater above a lower level.
Do I need fall protection on a roof?
For general industry working at a 4-foot height, or a low sloped roof, OSHA requires: … Between 6 feet and 15 feet from the edge: conventional fall protection (guardrail, fall restraint or fall arrest system) is required.
What is fall protection training?
Training includes review of legislation, the fall protection plan, fall protection methods required at the work site, identification of fall hazards, assessment and selection of anchors, instruction on correct use of connecting hardware, effects of a fall on the body, pre-use inspections, emergency response procedures, …