What security do Harley Davidsons have?

Factory Security System. The only security system designed and approved by the Harley-Davidson® Motor Company. When armed, the Security System disables the starter and ignition while monitoring the electrical system and vehicle motion with adjustable sensitivity.

How do I know if my Harley has security?

Registered. One way to tell for sure is to determine whether your bike has a Turn Signal Module(TSM) or a Turn Signal Security Module(TSSM) installed. TSM = no security system TSSM = security system. On the side of the module there should be a sticker with a H-D part number.

How does the Harley Davidson security system work?

When the motorcycle is parked and the ignition key is turned to OFF, the Harley-Davidson® Smart Security System arms automatically within five seconds if no motion is detected. Upon arming, the turn signals will flash twice and the optional siren will chirp twice.

What is the default Harley security code?

By Bikers For Bikers. VIDEO-If your Harley Davidson is equipped with a factory installed alarm then you really need to immediately change your security PIN code. Harley puts a standard factory preset PIN code and it is usually 31313.

IT IS INTERESTING:  Can never let your guard down?

Why is my Harley-Davidson asking for a PIN?

If you have a security-equipped Harley-Davidson, you know that without your key fob present, the bike will not start. … Using the left turn signal to cycle through the digits and the right turn signal to select and move onto the next slot, you enter your personalized five-digit PIN and your bike will start.

How much does a Harley Davidson key fob cost?

Compare to other motorcycle and car key, Harley Davidson key is one of the best keys to lose. The average cost for a replacement key made by vin is $50 and can be done by most if not all local authorized Harley Dealer.

What does the red key light mean on a Harley?

The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed.

How do you reset the code on a Harley Davidson?

Once you record the codes, you can clear them if you need to. To do that, press and hold the odometer reset button for longer than five seconds until the word “clear” is displayed. Once you see the word “clear,” release the reset button. Repeat these steps as you cycle through the codes.

How do you bypass the security system?

How To Bypass A Zone

  1. The system must be disarmed before you bypass any zones.
  2. Identify the two digit zone number that you need to bypass. …
  3. Enter your 4 digit master alarm code: _ _ _ _ + 6 (labeled BYPASS on most keypads) + zone number.
  4. Repeat this for each zone you would like to bypass.
IT IS INTERESTING:  Quick Answer: How does the electronic environment impact one's personal security?

How do I get my Harley out of transport mode?

When the vehicle is in the transport mode, the security system does not respond to motion detection. To exit the transport mode, use the key fob to disarm the vehicle.

How do I disconnect my Harley battery without alarm?

Re: How to remove the battery without alarm going off? Have the Fob near the bike and turn on the ignition then turn it off. This should reset the alarm.