The best way to reset a motion sensor light is to turn it off and back on again for a period of 30 seconds or longer. A homeowner can also turn the power to it off at the breaker, in order to ensure it has time to reset itself. If that doesn’t work, the sensor itself or the bulb may be to blame.
How do I reset my motion light stays on all the time?
Reset your Motion Detector – To reset your motion light, unplug it from its power source for a full 10 seconds. Plug it back in and allow it to come back on. This should reset your light and turn off the auto-on function.
Why is my outside security light staying on?
Your motion sensor light stays on. These lights are designed to go off after movement has ceased, generally within 30 to 60 seconds. If your motion sensor light won’t go off or stays on for long periods of time, it may require a reset. Your outdoor sensor lights are not working or they seem less sensitive than usual.
Why is my outdoor sensor light not working?
If the light won’t come on after adjusting and cleaning the sensor, try a simple trick. Turn off the circuit breaker that controls the light circuit and leave it off for 30 minutes. Turn on the breaker and see if the light comes on. … If the light doesn’t come on when you turn the breaker back on, try replacing the bulb.
Why does my motion light come on during the day?
The light comes on during the day. The “ON-TIME” switch is in the test position to allow light fixture operate during the day. Set the “ON-TIME” switch to the 1, 5 or 20 minute setting. … Heat or light from the lamp heads may be turning the motion sensor on and off.
How long should security light stay on?
How long do the security lights stay on? Most security lights have adjustable timers built into them. Some can be adjusted to stay on for as little as 10 seconds with a maximum of 30 minutes. Most home owners set their security cameras to stay on between 5 to 10 minutes.
How do you check security light in daylight?
To begin testing your light during daylight hours, slide the “On-Time” switch on the sensor head to the “Test” position. For the initial test, your “Range” (or “Sensitivity”) controls should be set to their lowest setting and all other features should be turned off.