Best answer: How do I fix my edge guard?

Why is my lawn stripes after fertilizing?

More specifically, the stripes are caused by not aligning the spreader as you make each pass. Most spreaders, either drop or broadcast, will have an “edge” where the fertilizer hits the lawn. … The stripes themselves are formed when the fertilizer is overlapped or gapped, thus creating light and dark stripes of green.

How do you calibrate fertilizer spreader?

How to Calibrate a Spreader

  1. Determine the amount of fertilizer needed for 100 sq. ft. For example, the fertilizer bag weighs 25 lbs. and covers 5,000 sq. …
  2. Place this amount in the spreader.
  3. Mark off the area. For a rotary spreader, use a 10-foot by 10-foot area (100 sq. ft). …
  4. Apply using the suggested setting.

What setting should my spreader be on?

Place your spreader setting on a low setting (usually one-fourth of the spreader setting range or less). Spread the material over a 50 x 20-foot area (1,000 square feet). If there is material left over, increase your setting. If you come up short, decrease your setting.

How do you clean a fertilizer spreader?

How do you clean a fertilizer spreader?

  1. Empty the hopper on the spreader of any remaining product.
  2. Remove all granules and fertilizer residues from the hopper and spreading components using high-pressure air with an approved air nozzle.
  3. Thoroughly wash the spreader and allow time for it to dry.
IT IS INTERESTING:  What is physical security in information security?

How do you clean a Scotts fertilizer spreader?

Depending on your spreader model you may have to only do 3 of the steps.

  1. Step 1 is to simply rinse your spreader. …
  2. Step 2 is to wash and dry your spreader. …
  3. Step 3 is to lubricate your machine. …
  4. Step 4 is to wipe down the stainless steel with some WD-40 or other spray/sealant.

How do you use Scotts edge guards?

Fill hopper with Scotts® lawn fertilizer or grass seed. Turn orange rate dial to the desired “Broadcast/Rotary Spreader” setting listed on the back of each Scotts® product. To apply product begin walking, then squeeze and hold trigger. NOTE: Each pass should be within 1.5 metres (5 ft.)